home | info | tutorials | sponsors | support | links | contact

How to Replace the Distributors & Rotors
1990-1994 Lexus LS400

By LexLS.com

Before doing anything read my disclaimer & safety info.

 

Notes

It's a good idea to replace your distributors and rotors while doing a tune up, or timing belt change since many parts have already been removed. Replacing these parts may also help if you're experiencing starting problems. There is a procedure for this in the repair manual but it leaves out many parts that need to be removed. The parts that need to be removed are almost exactly the same as in the timing belt tutorial so I'm just going to follow that and note the steps you'll need to follow.

Tools Needed:

Parts/Supplies Needed:

 

1) Drain engine coolant from radiator . Follow steps 4-5. Basically you only need to drain the radiator and make sure the overflow tank is empty.

2) Disconnect battery, remove fan, remove drive belt, and engine covers. Follow steps 2, 3, 5, 6, 8, 10, 11 and 12. Your distributors and rotors should now be removed.

4) Install the distributor rotors. Align the protrusion of the rotor with the groove of the camshaft timing pulley. Torque the 2 bolts to 34 in-lb (39 kg-cm, 3.8 Nm)

5) Install the two distributor caps. Each cap has 3 bolts, torque the bolts to 34 in-lb (39 kg-cm, 3.8 Nm).

6) Remaining install is reverse of removal.

 

 

Support LexLS.com

If you found this information useful please support the site by clicking the button below and making a donation. Thank you.

 

 

: home :: info :: tutorials :: sponsors :: support :: links :: contact :: site map :
Site best viewed at 800x600 or higher using Mozilla Firefox Get Firefox!
This is an enthusiast site and is not affiliated with Lexus/Toyota USA in any way.
Lexus/Toyota logos are trademarks of their respective companies.
Copyright © 2003-2012 C. Pearson. All rights reserved.
Last revised: Sunday, 27-Nov-2011 17:19:16 CST